Pre-Installation Assembly - HAMPTON BAY Hampton H300 Owners & Installation Manual

PRE-INSTALLATION
ASSEMBLY
After removing the stove from its packing, open
the front door and remove the contents from the
fi rebox, leaving the bricks in place.
Draft Control
Lever Handle
1) Insert bolt and lock washer through draft
control lever hole.
2) Place handle through bolt. Tighten to se-
cure.
Handle
Draft Control Lever
Hampton H300 Cast Freestanding Woodstove
This stove can be connected to either a top or
rear vent exit by simply reversing the orientation
of the elbow.
Simply remove the 2 screws, change the posi-
tion of the elbow as desired and secure in place
with screws.
1) Loosen the bolts that secure the elbow to
the unit. Ensure elbow does not fall off.
2) Bend the tabs on the rear heat shield inwards
90 degrees.
Bolt
Washer
3) Slide the tabs on the rear heat shield in
between the bolt and washer.
Please Note: The shield needs to be stretched/
fl exed in order to fi t in place.
Slide tabs in between
washer and bolt.
4) Once rear heat shield is evenly in place,
tighten bolts to secure.
Rotating Elbow
Rear Heat Shield
Bend tabs inwards 90 degrees.
Rear Heat Shield
INSTALLATION
Side Load
Door Handle
1) To install side door handle, remove side
door plug assembly.
Side Door Plug Assembly
Door Latch Bar
Hex Nuts
Flat Washers
2) Assemble handle by:
a) Placing lock washer over hex head bolt.
b) Place hex head bolt into handle.
c) Place spacer over hex head bolt
threads.
d) Screw handle into side door latch.
Latch
Spacer
Handle
Lock
Washer
3) Place side door handle latch through side
door hole.
4) Re-assemble side door plug assembly to
secure.
Side Door
Plug Assembly
Side Door
Plug
Hex Head
Bolt
Latch
7