Outside Fresh-Air Connection; Exhaust And Fresh Air Intake Locations - HAMPTON BAY GC60 Technical Manual

O F
UTSIDE RESH
This Heater must have adequate air for proper combustion in the room that it is installed.
A Fresh-air intake is strongly recommended for all installations. Failure to install intake air may
result in improper combustion as well as the unit smoking
during power failures.
The inlet to the intake must be below and a minimum of 12"
(30cm) away from the unit exhaust outlet.
Outside fresh air is mandatory when installing this
unit in airtight homes and mobile homes.
When connecting to an outside fresh air source, do not use
plastic or combustible pipe. A 3" minimum (76 mm) ID
(inside diameter) steel, aluminum or copper pipe or ducting
should be used. The inlet must have a screen installed. It is
recommended, when you are installing a fresh air system, to
keep the number of bends in the pipe to a minimum.
E A
XHAUST ND
This unit uses a 4" exhaust vent.
EXHAUST:
Base of unit to center of flue
Center of unit to center of flue
FRESH AIR INTAKE.
Base of unit to center of intake
Center of unit to center of intake
Hampton GC60 Cast Pellet Stove Technical Manual
-A C :
IR ONNECTION
F A I L
RESH IR NTAKE OCATIONS
15½" (392 mm)
6 / " (162 mm)
3
8
12" (305 mm)
4 / " (126 mm)
7
8
Installation
:
11.3
Figure 8: GC60 Inlet and Outlet Location.
Outside
Wall
3" ID
(76 mm)
Figure 7: Outside Air Connection.
4.9" 6.5"
Optional
Elbow
7.7"
11