If You Make A Mistake; Return To Factory Settings - Wasp Bar Code Laser Scanner Programming Manual

I Y M M
F OU AKE A
If, during a programming session, you find that you are unsure of the
scanner's settings or wish to re-set the scanner's configuration, use the
Return to Factory Settings label on this page to return the scanner's
configuration to the factory settings. Scanning this label will also reset any
changes made during previous programming sessions.
R F
ETURN TO ACTORY
Scan this label to return the scanner to the default settings configured at
the factory for your scanner's original interface specifications. This label is
typically used to return the scanner to a "known" operating state when the
present programming status is not known, faulty, or suspect.
Use this label with caution, since it
will disable ALL features that may
have been programmed since the
scanner's installation.
If you don't have a record of your site/system's original configuration, you
may need to call Informatics for assistance to return the scanner to normal
function. Please be prepared to provide information about the store/
chain, location, and other pertinent information about the scanner being
repaired.
...
ISTAKE
S
ETTINGS
7