S
ETTING
To set one ASCII character as a prefix or suffix, follow steps one through
four on the previous two pages (select prefix or suffix), then...
1. Scan the two digit Hex Code for that character.
(e.g. 03, 8F, ...FF)
If you make a mistake, or lose your place while setting this option,
scan the END label to exit Programming Mode. The scanner will
sound an error tone ( six rapid beeps ) to indicate that program-
ming was incomplete, and the setting will remain as it was before
entering Programming Mode.
2. Scan the ONE CHARACTER ONLY label on the following
page.
3. Scan the END label.
You have set a single character prefix or suffix.
S
You must scan the SET label and either the
SET PREFIX or SET SUFFIX label before using
the labels on this page.
0 -----------------------------
1 -----------------------------
2 -----------------------------
3 -----------------------------
4 -----------------------------
36
A S
C
INGLE
HARACTER
NOTE
P
/
ETTING
REFIX AND
NOTE
Wasp Laser Scanner Programming Guide
P
S
REFIX OR
S
C
OR
UFFIX
HARACTERS
UFFIX