Cannot Access The System Control Center; Computer Is Connected Directly To The Terminal; Terminal Is Connected To An Ethernet Device - Hughes HN7000S User Manual

Cannot access the
System Control Center
Computer is connected
directly to the terminal
Terminal is connected to an
Ethernet device
If you cannot access the System Control Center, refer to the
troubleshooting procedures for the appropriate hardware
configuration:
• Computer is connected directly to the terminal on page 55
• Terminal is connected to an Ethernet device on page 55
Follow the steps below if your computer is connected directly to
the terminal. If you complete a step and the System Control
Center does not appear, continue with the next step. Repeat the
steps once more before contacting your service provider.
1. Locate the shortcut to the System Control Center on your
computer desktop.
2. Double-click the shortcut icon.
3. If double-clicking the icon does not work, open a web
browser.
4. Type
www.systemcontrolcenter.com
address bar.
5. Press E .
NTER
6. If the System Control Center has not opened, type
in the browser's address bar.
192.168.0.1
7. Press E .
NTER
If your terminal is connected to an Ethernet device such as a
router or a wireless base station, follow these steps:
1. Disconnect the Ethernet cable from the device.
2. Connect the Ethernet cable to the Ethernet port on your
computer.
3. Restart your computer.
4. Attempt to access the System Control Center by completing
the steps in Computer is connected directly to the terminal at
the top of this page.
If you can access the System Control Center after connecting the
terminal directly to your computer, your Ethernet device may not
be properly configured. Refer to the documentation for your
Ethernet device to properly configure it. Be sure to re-connect the
terminal to the Ethernet device before attempting to access the
System Control Center.
in the browser's
Chapter 5 • Troubleshooting
1037073-0001 Revision E
55