Table of Contents
Advertisement
Answering system
Answering system settings
Remote access code
A 2-digit security code is required to access the answering system remotely
from any touch-tone telephone. The preset code is 19. You can change the
code to any number from 00 to 99.
To change the remote code:
1.
Press
MENU
main menu.
Use CID or
2.
press SELECT.
3.
Use CID or
press SELECT.
4.
Press CID or
press SELECT.
5.
Use the dialing keys (0-9) to enter a 2-digit number
from 00-99.
•
Press
MUTE
•
Press and hold
Press CID or
•
Press
SET
to save. You hear a confirmation tone.
Message alert tone
When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you to new messages. The tone stops when all new
messages have been reviewed. The default message alert tone setting is Off.
To change the setting:
MENU
1.
Press
main menu.
Use CID or
2.
press SELECT.
3.
Use CID or
press SELECT.
4.
Press CID or
press SELECT.
5.
Press CID or
SET
then press
NOTE: You cannot set the message alert tone when another handset or the telephone
base is accessing the answering system.
on the handset in idle mode to enter the
DIR to scroll to Answering sys, then
DIR to scroll to Ans sys setup, then
DIR to scroll to Remote code, then
/DELETE to erase a digit.
/DELETE to erase all digits.
MUTE
DIR to move the cursor to the right or left.
on the handset in idle mode to enter the
DIR to scroll to Answering sys, then
DIR to scroll to Ans sys setup, then
DIR to scroll to Msg alert tone, then
DIR to choose between On and Off,
to save your setting. You hear a confirmation tone.
78
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK
SELECT
REMOTE CODE
19
BACK
SET
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
SELECT
MSG ALERT TONE
On
Off
BACK
SET
Advertisement
Table of Contents
