Advertisement
Power Up
Ensure that the extraction system is on, and the flexible
duct is installed.
Switch on the
. Allow up to one minute for
the projector to finish the boot-up sequence. Boot-up is
complete when the
button turns green.
If the projector's
turns red, yellow or blue,
refer to the
section in this guide.
Remove the lens cap (if applicable).
Power Down
If the lamp is on, press the
button and allow
the lamp to cool for 10 minutes prior to electrical
power down.
Damage will result if you do not
allow the lamp to cool down!
After the 10 minute cool down period, switch off the
projector's
.
System Reboot Sequence
If the lamp is on, press the
button and allow the
lamp to cool for 1 minute.
Switch off the
.
After 30 seconds, turn
on, and allow 1 minute
for the system to boot, until
Continue with normal projector operations as required.
2
3
2
2
button turns green.
General Procedures
Playing a Movie Controlled by the Server
Play the movie from the server.
Check if the
Check if the
Check that the appropriate
Check the image on screen for proper alignment
and color.
: If the image is not aligned with the screen
masking, use the
image on screen. Be sure to notify the theater technician.
Playing a Movie Manually
During normal operations, the server should start the projector automatically.
If it does not start automatically, use the following steps.
Press the
turns green.
Select the appropriate
Allow a moment for the lens to move into position,
and the electronic "masking" files to be loaded.
Press the
Play the movie from the server.
Check the image on screen for the proper alignment
and color.
: If the image is not aligned with the screen
masking, use the
image on screen. Be sure to notify the theater technician.
Quick Start Guide — Operators
button turns green.
button turns green.
is selected.
to correct the
button. Check if the button
for the next show.
button if required.
to correct the
Advertisement
