Getting Started - Elcometer 148 Operating Instructions Manual

R

2 GETTING STARTED

1. Remove the protective cap. Unscrew the storage
Soaker Cap from the probe. Do not dispose of the
storage solution as it is required to keep the electrodes
wet and ready for continuous measurement.
2. If the electrode sensor is dry, a slow and sluggish
reading will result. Soak the electrodes in water or pH
solution for 15-30 minutes before use.
3. Rinse the sensor in tap water or preferably distilled
water.
4. Press the ON/OFF button once to switch on.
5. Temperature display is factory preset to °C. To switch
the display to °F reading, press and hold-down the
Mode button until reading is displayed in °F
6. Repeat step 5 to return it to °C.
7. Always replace storage soaker cap with some solution
in before storing the instrument.
4
Display
On-Off CAL Button
Storage Soaker Cap
(unscrew to release from probe)
Protective Cap
Attach wrist strap here
Battery Cap
°C-°F Button
Unscrew lock ring to
release electrode
Probe Electrode
Sensor