Targa Extender User Manual page 84

Set Supervisor Password
This field allows you to set the Supervisor password. To set the
Supervisor password, highlight this field and press the [Enter] key.
The following dialog box appears:
Confirm New Password
Type the password and press the [Enter] key. You can type up to
seven alphanumeric characters. Symbols and other keys are ignored.
To confirm the password, type the password again and press the
[Enter] key. The Supervisor password is now set. This password
allows full access to the BIOS Setup menus.
To clear a password, highlight this field and press the [Enter] key.
The same dialog box as above will appear. Press the [Enter] key
twice. The password is now cleared.
Set User Password
This field allows you to set the User password. To set the User
password, follow the same instructions for setting the Supervisor
password. The User password allows restricted access to the Setup
menus. This password also requires that the Supervisor password be
set prior to setting the User password.
Password on Boot
This option requires prior setting of the Supervisor password to
function. When enabled, the system will then require either the
Supervisor or User password before the system can bootup. The
options for this field are:
•
Disabled (default value)
•
Enabled
Fixed Disk Boot Sector
This option requires prior setting of the Supervisor password to
function. When set to Normal, the system will allow normal access to
the HDD boot sector. When set to Write Protect, the BIOS blocks all
accesses to the boot sector. The options for this field are:
•
Normal (default value)
66
Set Supervisor Password
Enter New Password [ ]
[ ]