Table of Contents
Advertisement
W
W
a
a
r
r
n
n
i
i
n
n
g
g
:
:
line in your CONFIG.SYS for APM (Advanced Power Management)
to work correctly while under DOS or Windows 3.x. Failure to use
POWER.EXE could cause the Notebook to become unstable or crash
during SUSPEND/RESUME operations. POWER.EXE is not
necessary while running Windows 95™ . For additional information
refer to your DOS User' s Manual.
How to Resume
Pressing the power button causes the system to resume operation after
entering the Suspend mode. Resuming returns the system' s operation
to the point in your application where the suspend mode was initiated.
This does not mean, however, that all devices are powered up. When
the system resumes, the following events occur:
•
DRAM refresh memory returns the system to the application that
was running before the Suspend operation
•
The video is turned on.
•
The COM ports are enabled.
•
Then, each device is powered on when it is requested for use by
the system.
Power Management Summary
Power Mode
System Idle
System Standby
System Suspend
(Suspend to Disk or
Suspend to RAM)
Hard Disk spin down
POWER.EXE must be loaded in a DEVICE =
How to Enter Mode
• Transits automatically
• Transits automatically
after specified time out
• Transits automatically
after specified time out.
• Press Power button.
• Battery low state.
• Transits automatically
after specified time out
How to Reactivate
• Press any key,
• Access HDD
• Press any key
• Press the Power
button
• Access HDD
43
Advertisement
Table of Contents
