Stopping Dhw Heating - Viessmann Vitotronic 300-K Operating Instructions Manual

DHW Heating
Setting the Time Program for DHW Heating
Heating system with DHW circulation pump
For further information about the DHW circulation pump,
see chapter "Terminology".
H Automatic mode is set for the DHW circulation pump
time program. In other words, the DHW circulation
pump operates in parallel to the DHW heating time
program.
H If you don't want the automatic mode, you can select
up to 4 individual time phases per day for the DHW
circulation pump, which can be the same for every day
of the week or different. Set the start and end points
for each time phase.
H In the "Information" menu, you can scan the current
time program (see chapter "Scanning information",
"DHW" group).
Note: Activating the DHW circulation pump is only
advisable for those times when DHW is actually
drawn.

Stopping DHW Heating

You do not want to have DHW or heat your rooms.
Extended menu
1.
2. Select the heating circuit, if necessary (see page16).
3. "Heating"
4. "Heating program"
5. "Standby mode" (frost protection monitoring)
24
Vitotronic 200 and 300-K Operating
(continued)
Extended menu:
1.
2. "DHW"
3. "DHW circ time prog"
4. "Individual"
5. Select part of the week or a day.
6. Select the time phase !, ?, § or $.
7. Set the start and end points for the relevant time
phase.
8. Press to exit the menu.
Note: If you want to terminate a time phase setting
process prematurely, keep pressing
required display appears.
Deleting a time phase
Set the time for the end point to the same time that was
set for the start point. The display shows the selected
time phase "- - : - -".
You do not want DHW, but do want to heat the rooms.
Extended menu
1.
2. Select the heating circuit, if necessary (see page 16).
3. "Heating"
4. "Heating program"
5. "Heating and DHW"
6. until the menu is displayed.
7. "DHW"
8. "Set DHW temperature"
9. Select 50º F (10° C).
until the