Canon LBP7110Cw Manual page 246

[Select Protocol]
[Auto IP]
When setting the IP address manually
Allows you to directly set the IP address manually.
[Select Protocol]
[Auto IP]
[IP Address]
[Subnet Mask]
[Gateway Address]
3
Specify the DNS.
Proceed to Step 4 when not using DNS.
[Primary DNS
Server Address]
[Secondary DNS
Server Address]
[Host Name]
Downloaded from ManualsPrinter.com Manuals
[Off]
An IP address that uses RARP, BOOTP, or DHCP cannot be obtained automatically.
[DHCP]
Obtains an IP address using DHCP. (The DHCP server needs to be running.)
[BOOTP]
Obtains an IP address using BOOTP. (The BOOTP daemon needs to be running.)
[RARP]
Obtains an IP address using RARP. (The RARP daemon needs to be running.)
[Off]
An IP address that uses Auto IP cannot be obtained automatically.
[On]
The printer obtains the IP address automatically.
Select [Off].
Enter the IP address of the printer.
Enter the subnet mask that is used on the TCP/IP network.
Enter the gateway address that is being used on the TCP/IP network.
Enter the IP address of the primary DNS server.
Enter the IP address of the secondary DNS server.
Enter the host name to be added to the DNS server. You can enter up to 47 single-byte
alphanumeric characters.