Rear Suspension - Arctic Cat S2008ACAAAUSG Operator's Manual

2. Using low-temperature grease,
lubricate the fitting on the speed-
ometer drive adapter until grease
is noted coming out along the
edge of the drive adapter.

REAR SUSPENSION

(Every 40 Operating
Hours)
 NOTE: Arctic Cat recommends
that Arctic Cat Low-Temp Grease
(p/n 4639-365) be used for this
procedure.
 NOTE: Determine which style
rear suspension is being lubri-
cated and locate the grease fit-
tings accordingly.
1. Shut engine off and wait for all
moving parts to stop.
LUBRICATION
2. With the gas tank nearly empty
(less than 1/4 full), lay the snow-
mobile on its left side. A piece of
cardboard should be used to pro-
tect the finish on the hood and
belly pan.
! CAUTION
The 660 cc models should not be
tipped on their sides for any rea-
son, as engine oil may seep into
the upper engine through the air-
intake system. Severe engine
damage could result if the engine
is run with oil in the upper engine.
0727-472
3. Remove ice and snow buildup
from the skid frame to expose the
grease fittings.
4. Lubricate the grease fittings with
low-temperature grease.
0741-376
45