Diagnostic Codes/Check Engine Light (660 Cc Models); Handlebar Tilt - Arctic Cat S2008ACAAAUSG Operator's Manual

Code Trouble
1 Failure in the fuel system.
1-1 Failure in speed sensor.
1-2 Failure in coil (#1).
1-3 Failure in coil (#2).
1-4 Failure in ISC valve.
1-5 Failure in oxygen sensor.
1-9 Failure in camshaft position
sensor.
2 Failure in injector (#2).
3 Failure in injector (#1).
4 Failure in barometric pressure
sensor.
5 Open or short circuit in intake
manifold air temperature sensor.
6 Open or short circuit in water
temperature sensor.
7 Open or short circuit in throttle
position sensor.
8 Open or short circuit in manifold
air pressure sensor.
9 Failure in crankshaft position
sensor.
DIAGNOSTIC CODES/
CHECK ENGINE LIGHT
(660 cc Models)
These diagnostic codes are flashed by
the check engine light incorporated
within the speedometer/tachometer
(Bearcat W/T Turbo model) or within
the gauge hole plate (Bearcat Wide
Track Non-Turbo/Panther 660 mod-
els). Refer to the following chart for
diagnostic code sequences.
 NOTE: On these double-digit
codes (1-1, 1-3, etc.), the first
number indicated will flash in an
uninterrupted sequence, there will
be a short pause, and the second
number indicated will flash in an
uninterrupted sequence.
20
Number of
Flashes Trouble
1-1 Open or short circuit in
(Check Engine manifold air pressure
Light) sensor.
1-3 Open or short circuit in
(Check Engine throttle position sensor.
Light)
1-4 Failure in oxygen sensor.
(Check Engine
Light)
1-5 Failure in crankshaft
(Check Engine position sensor.
Light)
1-6 Failure in speed sensor.
(Check Engine
Light)
1-7 Open or short circuit in
(Check Engine knock sensor.
Light)
1-8 Open or short circuit in
(Check Engine intake
Light) manifold air temperature
sensor.
1-9 Open or short circuit in
(Check Engine water temperature sen-
Light)
2-7 Failure in coil.
(Check Engine
Light)
2-9 Failure in barometric
(Check Engine pressure sensor.
Light)

HANDLEBAR TILT

The handlebar can be adjusted to the
position providing the operator with
the most comfort. To adjust the han-
dlebar, use the following procedure:
 NOTE: It may be necessary to
remove the handlebar cover for
this procedure.
1. Loosen the four lock nuts secur-
ing the handlebar caps and block
to the steering post.
GENERAL INFORMATION
sor.