Diagnostic Codes - Arctic Cat ZR4000 2016 Operator's Manual

H. Engine Hour Meter/
Odometer/Trip Meter/
Clock
This display shows engine hours, odome-
ter, trip meter, or clock. Press the Lower
Right Button to change which parameter
is being displayed. The Engine Hour
Meter and Odometer cannot be reset. To
reset the trip meter, select the Trip Meter;
then press and hold the Lower Right But-
ton until the trip meter display reads 0.

NOTE: The clock can only be dis-
played in this position if it is not
already being displayed in the main
right screen. To set the clock when
the clock is in this position, press
and hold the Lower Right Button;
then use the procedure found in G.

Diagnostic Codes

Diagnostic codes are activated by the
ECM and may be displayed on the read-
out screen for a number of reasons.
If a code is displayed while the engine is
running, the ECM is receiving input that
is outside of its established parameters. If
a code has been activated, take the snow-
mobile to an authorized Arctic Cat Snow-
mobile dealer for service. If not under
warranty, this service is at the discretion
and expense of the snowmobile owner.
6000
Code
P0112 Intake air temp sensor 1 circuit low.
P0113 Intake air temp sensor 1 circuit high
P0117 Coolant temp sensor 1 circuit low.
P0118 Coolant temp sensor 1 circuit high.
P0122 Throttle position sensor circuit low.
P0123 Throttle position sensor circuit high.
P0261 Cylinder 1 injector circuit low.
P0264 Cylinder 2 injector circuit low.
P0324 Knock control system error.
P0327 Knock control 1 circuit low.
P0328 Knock control 2 circuit high.
P0351 Ignition coil (A) primary/secondary.
P0352 Ignition coil (B) primary/secondary.
P0545 Exhaust temp sensor circuit low.
P0546 Exhaust temp sensor circuit high.
P1000 Oil pump flow not programmed.
P1001 Injector 1 offset not programmed.
P1002 Injector 2 offset not programmed.
P1003 Oil pump outlier.
Trouble
Code
P1004 ISC outlier.
P1005 Regulator voltage circuit low.
P1006 Regulator voltage circuit high.
P1007 Fuel pump circuit low.
P1008 Fuel pump circuit high.
P1009 Speed sensor malfunction.
P1261 Injector circuit/open - Cylinder 1b.
P1264 Injector circuit/open - Cylinder 2b.
P1329 Knock sensor loose detection.
P1636 Crank angle sensor circuit.
P1639 Exhaust valve position sensor circuit
low.
P1640 Exhaust valve position sensor circuit
high.
P1645 Exhaust valve system malfunction.
P1646 Exhaust valve actuator self-cleaning
open error.
P1647 Exhaust valve actuator short error.
P1755 Engine RPM sensor circuit malfunc-
tion.
P2228 Barometric pressor sensor (A) circuit
low.
P2229 Barometric pressure sensor (A) cir-
cuit high.
P3001 Control module improper shutdown.
U1000 Vehicle not registered or invalid PIN
entered.
U1001 Vehicle not registered and vehicle lim-
its enabled.
U0155 Lost communication with the ECM
ZR 4000/8000
Code
2 Failure in injector(s).
4 Open or short circuit in barometric
pressure sensor.
5 Open or short circuit in intake air tem-
perature sensor.
6 Open or short circuit in water tem-
perature sensor.
7 Open or short circuit in throttle posi-
tion sensor.
12 Failure in ignition coil(s).
16* Incorrect adjustment/failure in APV
cable.
17* Failure in exhaust temperature sensor.
18* Failure in servomotor.
21* Open or short circuit in/or loose knock
sensor.
OCTN* Low octane gasoline.
*8000
Trouble
Trouble
11