Loading Clips To The Pc - JVC GY-LS300CHU Instructions Manual

Loading Clips to the PC

You can load clips to a PC by connecting the
0
camera recorder to the PC via the USB port.
Doing so enables clips stored in the SD card to
be managed and edited on the PC.
Files on the SD card can be managed/edited on
0
the connected PC in this mode only for USB
mass storage class devices that are recognized
by the said PC as a peripheral drive.
Memo :
Files cannot be written to the SD card.
0
1 Connect the camera recorder to the PC
using a USB cable.
A confirmation message "Change to USB
Mode?" to enable the USB connection appears.
.
2 Select [Change] using the cross-shaped
button (JK), and press the Set button (R).
The camera recorder switches to USB mode.
.
Memo :
If recording is in progress, the "Change to USB
0
Mode?" message appears after recording
stops.
If playback is in progress, the camera recorder
0
switches to USB mode after the file closes
automatically, such as when playback stops.
Disconnecting
Disable the connection on the PC, then remove
0
the USB cable from the camera recorder.
Doing so exits the USB mode and switches the
0
camera recorder to Camera mode.
Memo :
PC
The procedure for disabling the USB connection
0
varies according to the PC in use. For details,
refer to the "INSTRUCTIONS" of the PC.
Change to USB Mode?
Change
Cancel
Loading Clips to the PC
2
25