Table of Contents
Advertisement
Basic Shooting
Procedures
Preparations
4
2
3
.
1 Supply battery or AC adapter power to the
camera recorder.
2 Insert an SD card.
3 Turn on the power of the camera recorder.
Hold down the lock button (blue) at the center of
the [POWER ON/OFF] switch to set to "ON". The
camera recorder starts up in Camera mode and
is ready for recording.
4 Adjust the angle of the LCD monitor and
viewfinder.
5 Set [System], [Format], [Resolution],
[Frame Rate] and [Bit Rate] in [Main Menu]
B [System] B [Record Set] B [Record
Format].
You can select the resolution of the recorded
0
videos (4K, HD, SD, or Web), file format for
recording/playback, and the video recording
format on this camera recorder.
Press the [MENU/THUMB] button on the
0
LCD monitor to display the menu screen on
the LCD monitor and viewfinder.
The following setting values are the factory
0
defaults.
[System]: HD
[Format]: QuickTime
[Resolution]: 1920x1080
[Frame Rate]: 60i (U model) or 50i (E model)
[Bit Rate]: 35M(UHQ)
6 Set the scan range according to the lens
attached as necessary using [Main Menu]
B [System] B [Record Set] B [VSM].
Memo :
Through setting the scan range using VSM
0
(Variable Scan Mapping), it is possible to
prevent or reduce the vignette effect.
Shooting
4
1
.
1 Press the [REC] button to start recording to
the SD card.
This camera recorder has two [REC] buttons.
Any of the [REC] buttons can be used to start/
stop recording by default.
The tally lamp lights up in red during recording.
Zoom Operation
0
Adjusting the Focus
0
Memo :
If both the slots are loaded with recordable cards
0
in the factory default, pressing the [REC] button
starts recording only to the media in the selected
slot.
When [Main Menu] B [System] B [Record Set]
B [Slot Mode] is set to "Dual", recording can be
performed simultaneously to the cards in both
the slots.
The tally lamp can be turned off in [System] B
0
[Tally Lamp].
Basic Shooting Procedures
21
Advertisement
Table of Contents
