A&D SB-30 Instruction Manual page 8

Setup Menu Mode /
To place the unit in Setup menu mode:
1. Turn the power off to the unit.
2. Locate the calibration switch on
the scale's back panel and toggle
to the opposite position.
3. While holding down both the
ZERO and PRINT keys, turn the
power back on.
4. When the display shows "F1",
the unit is in Setup Menu mode,
and you can release the two
keys. Shown at right are the di-
rectional and SET key assign-
ments
F1
Display Mode
0 1
To place the unit back into the Normal Operating mode:
1. With the scale on or off, toggle the Calibration Switch back to its original position. Turn the scale
back on without pressing any keys.
2. The display will go through a digit check, then settle into Normal Operating mode. All front panel
keys will now return to their normal mode of operation.
3. There is an F13 sub-menu present that is for FACTORY USE ONLY!
8
Revision 04/2001
Continued
SETUP MENU CHART
F9
F6
Calib. Unit.
Zero Range
100% 1.9% 0 1
SET
F11 F12
Display Check Calibration
Press ZERO Press ZERO
key to begin key to begin