Table of Contents
Advertisement
Troubleshooting
Check
Is it time to replace the lamp?
Projection stops automatically
Check
Is Sleep Mode enabled?
Problems when projection starts
The projector does not turn on
Check
Is the power turned on?
Is Child Lock set to On?
Do the indicators turn on and off when the
power cord is touched?
Problems with the remote control
The remote control does not respond
Check
Is the remote control light-emitting area
pointing towards the remote receiver on the
projector during operation?
Is the remote control too far from the projec‐
tor?
Is direct sunlight or strong light from fluores‐
cent lamps shining onto the remote receiver?
Are the batteries dead or have the batteries
been inserted correctly?
When the lamp is nearly ready for replacement, the images be‐
come darker and the color quality becomes poorer. When this
happens, replace the lamp with a new lamp.
If the set time is exceeded and no signal is input, the lamp turns
off automatically, and the projector enters standby status. The
projector returns from standby status when you press the
button on the remote control or the
panel. If you do not want to use Sleep Mode, change the setting
to Off.
Settings - Operation - Sleep Mode
s
Press the
button on the remote control or the
on the control panel.
When Child Lock is set to On from the Configuration menu, hold
down the
button on the control panel for approximately
three seconds, or perform operations from the remote control.
Settings - Lock Setting - Child Lock
s
Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
center.
Epson Projector Contact List
s
Point the remote control towards the remote receiver. Also,
check the operating range.
Check the operating range.
Set the projector up in a location where strong light does not
shine onto the remote receiver.
Make sure the batteries are inserted correctly or replace the bat‐
teries with new ones if necessary.
96
Remedy
p.106
s
Remedy
button on the control
p.79
Remedy
p.79
Remedy
p.23
s
p.23
s
p.23
s
button
Advertisement
Table of Contents
