Table of Contents
Advertisement
Useful Functions
Name
a
button
t
b Input button
c Output button
d Main power switch
e AC adapter port
f Optical Audio-Out port
g HDMI Output port
h HDMI Input port
i 3D Glasses charging port
j Setup button
k
indicator
t
(orange/green)
l WiHD indicator
(orange)
m Link indicator
(orange)
c
•
The receiver is located within the intake vent of the projector and therefore cannot receive any signals
directly from the rear. Set up so that the front of the projector is facing the WirelessHD Transmitter.
Also, make sure that the air intake vent on the left-hand side of the projector is not covered.
•
Place the WirelessHD Transmitter on a level surface facing towards the projector.
•
You can view the signal strength from the WirelessHD settings menu.
Video Reception
Turns the transmitter on or off.
This performs the same function as the
ter control on the lower section of the remote control.
Changes to the image from each input port.
This performs the same function as the
ter control on the lower section of the remote control.
Switches the output image to the Wireless or Output port.
This performs the same function as the
ter control on the lower section of the remote control.
Turns the main power for the transmitter on or off.
Connects the AC adapter.
Connects to audio devices equipped with an optical digital audio input port.
Connects to monitor devices, such as televisions. You can switch the output
using the Outputbutton.
Connects to the AV device you want to playback. You can switch the input
image using the Input button.
The HDMI5 port of the unit meets the MHL standards. You can play content
from MHL compatible smart devices or tablets connected with an MHL ca‐
ble.
Connects a USB cable to charge the 3D Glasses.
This is the button on the back of the WirelessHD Transmitter. It is used for
setting the WirelessHD Transmitter.
Lit when the WirelessHD Transmitter is on. Lit orange when standing by,
and green when operating (receiving or transmitting images).
Indicates the communication status for the WirelessHD.
•
Lit when wirelessly transmitting images to the projector.
•
Off when outputting to the Output port.
Indicates the connection status with the projector.
•
Turns on when connected to the projector.
•
Flashes when searching for a projector.
•
Flashes slowly when standing by in power saving status.
p.79
Function
55
button for WiHD Transmit‐
button for WiHD Transmit‐
button for WiHD Transmit‐
Settings - WirelessHD -
s
Advertisement
Table of Contents
