Ethernet port
The M12 and M14 provide a fully IEEE compliant 10BASE-T or 100BASE-T
Ethernet port for switch management. The port has two LEDs that indicates:
v Speed (10 Mbps or 100 Mbps)
v Status of the connection
Additionally, each CP has its own Ethernet port. You can choose to connect the
Ethernet ports to each other through an Ethernet switch or to connect them to
separate networks for greater availability. Each CP has its own unique IP address
and is accessible independent of the other CP.
Serial port
Each CP comes with two serial ports. The top serial port on the installed CP is an
RS–232 port that is used for remote dial-in. The bottom port is used for accessing
the console.
Numbering
The M12 and M14 switches use a numbering scheme that progresses from left to
right and bottom to top in numerical order. The reference location is from the cable
side of the chassis.
v Blade assemblies are numbered from 1—10, from left to right.
v Ports are numbered from 0—15, from bottom to top.
v Power supplies are numbered from 1—4, from bottom to top.
v Blowers are numbered from 1—3, from left to right.
Rack mounting
The mechanical design of the M12 and M14 allows rack mounting with either the
cable side or the noncable side facing the front of the equipment rack. The chassis
fits into a standard 19-inch EIA rack. Each chassis measures:
v 43.74 cm (17.22 in.) wide
v 70.87 cm (27.9 in.) deep (without the door)
v 61.24 cm (24.11 in.) high (less than 14U)
Cooling system
The M12 and M14 use a redundant system of three hot-swappable blowers. Cool
air intake is from the noncable side of the chassis, is pressurized, and is forced
through the system. Heated air exits at the top of the cable side of the chassis. The
unit is cooled by three blowers that are used in conjunction with a pressurized
plenum. Each blower assembly includes a blower control assembly, which provides
the following features:
v Blower status LEDs
v Blower speed sensing
v Blower speed control
v Serial electronically erasable programmable read only memory (EEPROM) that
v Inlet air temperature monitoring
8
IBM TotalStorage SAN Switch: 2109 Model M12 and Model M14 User's Guide
contains the part number, revision level, and error logs for the blade assembly