Table of Contents
Advertisement
9.8
Electrical Connection
This operation must only be performed by special-
ised technical personnel or by the service provider.
The machine is designed to work with single-phase voltage
matching the rating indicated on the identifi cation plate (section
1.4 "Machine Identifi cation").
Before plugging in the machine, make sure that the power button
is switched to "0".
The Service Provider makes and is responsible for the electrical
connection of the machine.
The machine should be connected to the mains using the plug
installed on the power cord, in accordance with:
• The Laws and Regulations in force at the place and time of
installation;
• The information shown on the technical specifi cations plate
on the side of the machine.
Warning: The electric socket which the appliance
is connected to should be easily accessible by the
user, in order to allow it to be easily disconnected from
the mains when necessary.
It is forbidden to:
• Use extensions of any kind.
• Replace the original plug.
• Use adapters.
9.9
Turning on/off the Machine
The machine can be turned on/off by pressing the button located
to the rear of the machine (Fig.02, page 3).
9.10 First Use - Use After a Long Period
of Inactivity
For a perfect Espresso: Rinse the coff ee circuit if using the
machine for the fi rst time or after a long period of inactiv-
ity.
These simple operations will allow you to always brew excellent
coff ee. They have to be performed:
A) At fi rst start-up;
B) When the machine remains inactive for a long time (more
than 2 weeks).
Machine Installation - Service Provider Manual
9.10.1 At First Start-up
To turn on the machine simply press the " " button (21). The
control panel indicates that the circuit must be primed.
1
Place a large container under the dispensing spout (Fig.11,
page 3).
The machine automatically starts circuit priming. It will then carry
out the warm-up and rinse cycle as described in section 3.4.
9.10.2 After a Period of Inactivity
1
Empty the water tank, wash and rinse it and fi ll it with fresh
water (see section 9.6).
2
Place a large container under the dispensing spout (Fig.11,
page 3).
3
Press the "
4
The machine will brew coff ee through the dispensing spout
(Fig.11, page 3); wait until the procedure is complete and emp-
ty the container.
5
Repeat the operations from step 2 to step 4 three times, then
continue with step 6.
Place a container under the steam/hot water wand (Fig.10,
6
page 3).
7
Press the "
Dispense water until the no water icon is displayed.
8
When the hot water dispensing procedure is complete,
empty the container.
" button (19) to start the brewing procedure.
" button (23) to start dispensing HOT WATER.
• 25 •
Hide quick links:
Advertisement
Table of Contents
