Table of Contents
Advertisement
10 MACHINE PROGRAMMING
All the operations described in chapter 10 must
be performed exclusively by the service provider
or a specialised technician, who shall organise
all the operating steps and use only suitable means to en-
sure strict compliance with the safety regulations in force.
The specialised technician or the service provider can change
some of the machine operating parameters to suit the needs of
the users.
10.1 Accessing the Programming Mode
Proceed as follows to access programming mode.
1
With the machine turned on, press and hold the "
button (22) and the "
" button (23) at the same time for 5
seconds.
2
The following screen is displayed:
3
Press the "
" button (21) to access programming mode.
Note: The above mentioned procedure can only be
used to access the programming menu when the
machine has reached operating temperature. To execute
certain programmes (e.g. DESCALING), the machine will
manage the procedure automatically and warm up ac-
cording to the manufacturer's settings.
Machine Installation - Service Provider Manual
Note: After 3 minutes of inactivity, the machine
will exit programming mode and return to stand-
ard operating mode.
The menus should be PASSWORD-protected.
The PASSWORD will not be requested if set on the
default value (0000). It should be changed upon
st
1
use to prevent unauthorised access. After this change,
it should be entered again at each access, every time the
display shows:
"
Refer to section 10.4 on how to set the PASSWORD.
To enter the password:
1
Press the "
number.
2
Press the "
(when it gets to the end it will start again from the beginning).
3
Repeat steps 1 and 2 until the set password has been entered.
4
Press the "
gramming mode.
P S W
0 0 0 0
CONFIRM
" (18) or " " (20) button to set the desired
" button (24) to move on to the next number
" button (21) to confi rm and to access pro-
• 29 •
Hide quick links:
Advertisement
Table of Contents
