Saeco Lirika Operating Instructions Manual page 37

15 Place a container under the steam/hot water wand and an-
other one under the dispensing spout.
16 Rinse the water tank thoroughly and fi ll it again with fresh
drinking water up to the MAX level.
17 Insert the tank into the machine.
18 Press the " " button (18); the machine performs the rinse
cycle.
Note: The rinse cycle can be paused by pressing
the " " button (18). To resume the cycle, press
the " " button (18) again. This allows you to empty the
container or to leave the machine unattended for a short
time.
19 When this icon is displayed, the water tank is empty. Repeat
steps 13 to 18. Then continue with step 20.
When the amount of water needed for the rinse cycle has
20
been completely dispensed, this icon is displayed.
Press the " " button (22) to quit the descaling cycle.
Note: The two rinse cycles are performed in order
to have the circuit cleaned with a preset amount
of water and ensure proper machine operation. If the wa-
ter tank is not fi lled up to MAX level, the machine might
require three or more cycles.
Machine Installation - Service Provider Manual
21 Once the rinse cycle is complete, the machine carries out the
warm-up and rinse cycle to be ready for product brewing.
22 Empty the containers used to collect the liquid dispensed by
the machine and reassemble the dispensing spout.
23 Empty the drip tray and place it back.
24 The machine is now ready for use.
Reassemble the Pannarello end part.
25
Note:
- The descaling solution must be disposed of according
to the manufacturer's instructions and/or regulations
in force in the country of use;
- After completing the descaling cycle, wash the brew
group as described in the "Weekly Cleaning of the
Brew Group" section in the "Cleaning and Mainte-
nance" chapter;
When the descaling cycle is complete, the drip tray must be emp-
tied.
• 37 •