Assembly-Siting; Disposal Of Packaging; Filling The Water Tank; Filling The Coff Ee Bean Hopper - Saeco Lirika Operating Instructions Manual

Machine Installation - Service Provider Manual
9.4

Assembly-Siting

The machine should not be installed outdoors or
in environments in which jets of water or steam
are used.
The presence of magnetic fi elds or proximity to
electrical machines which generate interference
could cause the electronic controls of the machine to
malfunction. At temperatures close to 0°C, internal parts
containing water are at risk of freezing. Do not use the
machine under these conditions.
To ensure correct and effi cient performance of the appliance,
comply with the following recommendations:
• room temperature: 10°C - 40°C;
• maximum humidity: 90%;
• the site should be suitably prepared for the installation of the
machine;
• the surface on which the machine is installed should be level,
solid and stable, with a gradient of max. 2°;
• the location should be adequately lit, ventilated and clean,
and the power socket should be easily accessible.
Access to the machine and the plug should be kept
clear at all times, in order to allow users to easily
reach them and to leave the area immediately if required.
The following illustration shows the required access distances:
• to the keypad on the front of the appliance;
• to the service units in the event of malfunction.
• 24 •
After placing the packaged product near the installation site, pro-
ceed as follows:
• ensure that the packaging has not been tampered with dur-
ing transport and that the original packaging is intact and
closed;
• open the packaging;
• check the condition and model of the machine;
• check the content of the accessories bag enclosed with the
machine (see "9.3 List of Accessories");
• remove the machine from its original packaging;
• remove any remaining packaging from the machine;
• lift the machine and place it in the designated area.
9.5

Disposal of Packaging

After opening the outer box, it is recommended that the packag-
ing materials are separated according to type and disposed of in
accordance with the regulations in force in the country of use.
We recommend keeping the outer box for future
transfers or transportation.
9.6

Filling the Water Tank

Before turning on the machine, the water tank should be fi lled
with fresh drinking water.
Warning! Before using the machine for the fi rst
time, wash the water tank carefully. Fill the water
tank with fresh drinking water only. Hot or carbonated
water, as well as other liquids, will damage the machine.
Refer to section 3.1. to carry out the procedure correctly.
9.7

Filling the Coff ee Bean Hopper

Before turning on the machine, check that the hopper contains a
suffi cient quantity of coff ee beans.
Warning! Only coff ee beans must be put into the
coff ee bean hopper. Ground coff ee, instant coff ee
or any other object may damage the machine.
Refer to section 3.2. to carry out the procedure correctly.