Table of Contents
Advertisement
Identifying the Switch Settings
The following list identifies each switch setting and its function.
Switch 1 — Password override — The default setting is "OFF." If you forget your
!
password and cannot access the data on your NEC Versa, change the setting to
"ON" and your current password is erased.
Switch 2 — Keyboard select; Default is "ON" for U.S. 86 key keyboard and "OFF"
!
for European keyboard.
Switch 3 — Not assigned; must be "OFF."
!
Switch 4 — Keyboard select 2; Default is "ON" for US and "OFF" for European
!
keyboards.
Switch 5 — Reserved for factory use; Default is "ON."
!
Switch 6 — Logo select; Default is "OFF."
!
Note
need to install/replace SO-DIMM modules, you might want to do so when the system is
already disassembled.
Replace the memory module bay cover and screw.
1.
Turn over the system.
2.
Follow the instructions earlier in this chapter, "Performing the BIOS Update."
3.
3-20 Using the BIOS Setup Utility
Default switch settings
The system memory expansion slot is also located here. Therefore, if you
Advertisement
Table of Contents
