Bay Window Mantis Log Set Installation Instructions - Empire Comfort Systems BF28(B,C,G)M(N,P)-5 Installation Instructions Manual

Power-vent high-efficiency fireplace
Hide thumbs Also See for BF28(B,C,G)M(N,P)-5:
Table of Contents

Advertisement

BAY WINDOW MANTIS LOG SET INSTALLATION INSTRUCTIONS

Log Installation
Proper positioning of the logs is critical to the safe and clean op-
eration of the fireplace. If the logs are not placed in the proper
position, the fireplace can soot, or create an unsafe operating con-
dition.
CAUTION
Do not handle these logs with your bare hands! Always
wear gloves to prevent skin irritation. After handling the
logs, wash your hands gently with soap and water.
Firebox Layout
Installation Sequence
1. To access the log set parcel, lift off the top panel.
2. Pivot the left and right panels open.
3. Unhook the main door latches located on the right and left
side of the fireplace, then remove the door.
4. Place the Rear Right Log (B) and the Rear Left Log (A) behind
the rear burner all the way against the back of the firebox. See
Figure 58.
A
30259-6-0314
Figure 57
B
Figure 58
5. Place the Front Left Log (C) into the front left corner of the
firebox, and position into the notch on the bottom left of Log
(A). See Figure 59.
C
A
6. Place the Center Log (D) over the flame sensors in the middle
of the firebox. Log (D) should be positioned to the left side of
the firebox. See Figure 60.
A
C
B
Figure 59
D
B
Figure 60
Page 33

Advertisement

Table of Contents
loading

Table of Contents