Table of Contents
Advertisement
The Mantis should be inspected and serviced annually by a quali-
fied service person. This will ensure that the fireplace is operating
safely and efficiently. Should you suspect any abnormal opera-
tion, contact a service person that has been trained to service this
product.
Cleaning the Glass Door
After the initial paint curing, a slight film may form on the glass. It is
recommended to clean the glass with gas fireplace glass cleaner.
The glass will need to be cleaned periodically during the year. Use
care when removing and cleaning the glass. In the event the glass
needs replaced, contact a qualified service person. Only glass ap-
proved by Empire Comfort Systems Inc. may be used, any substi-
tute glasses will void the warranty.
CAUTION
Do not attempt to clean the glass when it is hot. Do
not strike or hit the glass.
WARNING
Do not operate this fireplace without the glass door
in place. Do not operate if the glass front is broken or
damaged. Do not use the glass door if the gasket is
missing or is damaged.
CAUTION
Be certain the glass is cool before handling.
BAY WINDOW MANTIS MODELS
Removing the Glass Door
1. Remove the top of the cabinet.
2. Open the panels on the left and right sides. The panels pivot
in place.
3. Release the two door latches on both the left and right sides
of the firebox.
4. Carefully grab the glass frame and pull towards you. Do not
damage or remove the gasket from the door.
FIREPLACE MANTIS MODELS
Removing the Glass Door
1. Remove the lower louvered panel by lifting up then pulling
out.
2. Release the two hinge clips on underside of firebox.
3. Angle the bottom of glass assembly approximately 60 de-
grees out from firebox. Gently pull glass assembly away from
firebox. Do not damage or remove the gasket from the door.
30259-6-0314
MAINTENANCE & SERVICE
Resetting the Fireplace
To reset the fireplace, first turn both burner switches to the OFF
position. Verify the red button next to the burners is not illuminated.
If a Remote Control is fitted, turn the remote to the "OFF" position.
Turn the power off at the power source for 5 minutes.
Turn the power back on, and verify the L.E.D. lights on the Control
Panel Circuit Plate are illuminated. The burners should ignite in
approximately 60 seconds. The circulating blower will start in 3 to
5 minutes. The blower may continue to operate after the burners
are turned off.
WARNING
Potential risk of fire, electric shock, and personal injury.
Take precautions to reduce such risks
CAUTION
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
If equipped, the Mantis can also be reset by switching the main
power switch to the "OFF" position for 5 minutes. See Figure 77.
Figure 77
Page 49
Advertisement
Table of Contents
