Log Set Installation Instructions - Empire Comfort Systems PV-28SV50-BN-1 Owner's Manual

Power-vent high-efficiency fireplace with bay window
Hide thumbs Also See for PV-28SV50-BN-1:
Table of Contents

Advertisement

LOG SET INSTALLATION INSTRUCTIONS

Log Installation
The gas log set (front left log, front right log, center log and rear
log) is pre-set and installed in the factory. Only the top left log and
top right log are packaged separately inside the firebox for instal-
lation by the installer.
1.
To access the log set parcel, lift off top panel.
2.
Pivot left and right panels open.
3.
Unlatch main door latches located on right and left hand side
of the heater, remove door.
4.
Carefully remove top left log and top right log from firebox
and remove cardboard protection from center log and middle
log and all packaging materials.
Note: Positions of front left log, front right log, center
log, and rear log have been preset at the factory and their
locations should not be changed. Check that logs have not
been damaged in transit.
5. Carefully remove wrapping from top left log and top right
log.
Note: Before you begin: Do not handle these logs with your
bare hands! Always wear gloves to prevent skin irritation.
After handling logs, wash your hands gently with soap and
water.
The Gas Log Kit contains the following:
1)
Rear Log
2)
Center Log
3)
Top Right Log
4)
Top Left Log
5)
Front Left Log
6)
Front Right Log
Page 18
All Logs
The positioning of the logs is critical to the safe and clean
operation of this heater. Sooting and other problems may result if
the logs are not properly and firmly positioned in the appliance.
6. Prior to positioning of top left log and top right log,
7. Position top left log into locating pin on rear log and rest on
8. Position top right log into locating slot on rear log. See
9. After top left log and top right log have been placed in
TOP LEFT LOG
REAR LOG
FRONT LEFT LOG
Figure 15
LOG SET DIAGRAM - A
4 - TOP LEFT LOG
5 - FRONT LEFT LOG
Figure 16
inspect front burner and rear burner for particles or dust
accumulation on top of burners. If any particles or dust is
visible on top of front or rear burners, remove particles before
placing top left log and top right log into position.
center log. See Figure 15.
Figure 15.
position and safety check has been carried out, install door
and latch securely with latches located on right and left side
of heater.
TOP RIGHT LOG
CENTER LOG
FRONT RIGHT LOG
1 - REAR LOG
2 - CENTER LOG
3 - TOP RIGHT LOG
6 - FRONT RIGHT LOG
24820-2-0709

Advertisement

Table of Contents
loading

Table of Contents