Mounting The Camera; Checking The Camera Balance - Vinten Vision 3 Operator's Manual

Pan & tilt head
Table of Contents

Advertisement

Mounting the camera

Mounting the camera (3/8 in. mounting screws)
Remove the slide plate
lock release
(8)
and pulling the plate out to the rear.
Attach the slide plate to the camera or camera mounting plate under the approximate centre of
the camera's weight using both mounting screws (15).
Set the platform level and apply both the pan and tilt brakes (5)(7).
Push the slide plate and camera into the track in the platform, ensuring the slide lock release (8)
snaps into position.
Check the balance of the camera (see
Mounting the camera (VHS adaptor)
The VHS adaptor
(16)
by a plastic link.
To mount the camera using the VHS adaptor, proceed as follows:
Remove the slide plate
the slide lock release
Remove the two 3/8 in. BSW camera mounting screws
Position the VHS adaptor
wards. Screw the pin securely into the slide plate.
Secure the slide plate to the camera with the 1/4 in. BSW camera mounting screw, ensuring
the pin engages in the hole in the camera.
Set the platform level and apply both the pan and tilt brakes (5)(7).
Push the slide plate and camera into the track in the platform, ensuring the slide lock re-
lease
(8)
snaps into position.
Check the balance of the camera (see

Checking the camera balance

The Vision 3 pan and tilt head is available in different balance spring configurations, which enables
it to balance a wide range of cameras.
Check the camera balance as follows, remembering to ensure that the pan bar(s) and any ancil-
lary equipment have been fitted:
NOTE:
Be prepared to prevent the head falling away suddenly.
Reduce tilt drag
Release the tilt brake (7).
(9)
from the head by releasing the slide plate clamp (13), pressing the slide
Checking the camera
consists of a VHS pin and a 1/4 in. BSW camera mounting screw connected
(9)
from the head by releasing the slide plate clamp (13), pressing
(8)
and pulling the plate out to the rear.
(16)
in the longer slot in the slide plate, with the pin facing for-
(11)
to minimum.
balance).
(15)
from the slide plate.
Checking the camera
balance).
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents