Operation; Installing The Head On A Tripod - Vinten Vision 3 Operator's Manual

Operation

Installing the head on a tripod

The Vision 3 pan and tilt head is supplied with an integral 75 mm ball mount, designed for instal-
lation on a compatible Vinten Vision tripod.
Adaptors are available which enable the head to be installed on tripods or pedestals fitted with
other mountings. These are listed under Optional accessories - tripod and pedestal adaptors.
To install the head, remove the bowl clamp assembly (12) from the head, position the head on the
tripod and refit the bowl clamp assembly from below. Level the head with the aid of the level bub-
ble (4) and tighten the bowl clamp. The level bubble may be illuminated by pressing the switch (2).
The light will extinguish after approximately 15 seconds.
(9)
(16)
(15) (13)
(8)
Mounting the camera (VHS adaptor)
8