Kodak DCS 410 User Manual page 64

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B. If there is an external SCSI terminator between the end of a cable
5. Select the SCSI cable with the 50-pin connector at one end and the
25-pin connector at the other end.
IMPORTANT: Use only the cable supplied with the camera; do not use a
substitute cable.
6. Connect the 50-pin connector to the empty connector on the last SCSI
device in the chain. Make sure the connector is well seated by press-
ing it into place firmly, and then pinch the thin wire clamps over its
base.
©
4-20 Preparing the Camera and the Computer
and a SCSI connector on a device, remove the terminator, and
then reconnect the cable. (Later, if you remove the camera cable
from your computer, remember to replace this terminator.)
50-pin Connector 25-pin Connector
50-pin Connector
G
25-pin Connector