Installing The Software Driver - Kodak DCS 410 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installing the Software Driver

This section describes how to update the driver on your hard disk, and
how to update the firmware in your camera using the updated driver files.
The section assumes that you have obtained driver files as described
earlier in this appendix.
1. Complete all the steps in "Installing the KODAK Driver" in Chapter 4,
except that if the files have been downloaded from a network —
instead of obtained on a diskette — access the files from the location
of the downloaded data (since there is no diskette).
2. Access the new driver by completing all the steps in "Accessing the
Camera from the Driver" in Chapter 4.
3. Update your camera with the new firmware by completing all the
steps in "Updating Camera Firmware" in Chapter 4.
The software and camera are now ready for use.
©
Updating Your KODAK Software Driver
G
C-3