Kodak DCS 410 User Manual page 263

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message
"The camera is performing
another operation. Wait
briefly and try again."
"The camera or camera
back was not found. Try
the following.
Check all cables.
©
Check for SCSI ID
©
conflict.
Check for dead battery.
©
Switch to an archive
©
folder."
Possible Cause
You have tried a
command (for example
Copy To), and the
camera is still performing
another operation.
The SCSI cable is not
connected properly.
The camera SCSI ID is set
improperly.
You have connected the
camera to a different
computer (or to the same
computer to which you
recently connected an
additional SCSI device),
resulting in a SCSI ID
conflict.
Reference — Kodak Driver Software
©
Suggested Solution
Wait for a short time (for example
wait until the red Card Busy light
on the camera back stops
blinking), and then try again.
Verify that the SCSI cable is
connected properly between the
computer and the camera. If not,
turn both off, reconnect the cable,
and try again.
Reset the camera SCSI ID so that it
is different from other devices
connected to the computer. To do
so, turn off the camera, then the
computer. Reset the camera SCSI
ID. Restart.
(With a Macintosh computer the
CD-ROM drive is often SCSI ID
number 3; be certain that you
avoid its number.)
Reset the camera SCSI ID so that it
is different from other devices
connected to the computer. To do
so, turn off the camera, then the
computer. Set the camera SCSI ID
to a unique value. Restart.
(With a Macintosh computer the
CD-ROM drive is often SCSI ID
number 3; be certain that you
avoid its number.) (Continued on
next page.)
G
8-67