Show Commands For Port-Access Supplicant - HP procurve switch 2650 Access Security Manual

Show Commands for Port-Access Supplicant

Syntax: show port-access supplicant
Shows the port-access supplicant configuration (exclud-
ing the secret parameter) for the ports configured on the
switch as supplicants. The Supplicant State can include
the following:
For descriptions of the supplicant parameters, refer to
"Configuring a Supplicant Switch Port" on page 19.
[ e ] < port-list >
[ statistics ]
[ e ] < port-list >
Configuring Port-Based Access Control (802.1x)
Displaying 802.1x Configuration, Statistics, and Counters
Connecting - Starting authentication.
Authenticated - Authentication completed (regardless
of whether the attempt was successful).
Acquired - The port received a request for
identification from an authenticator.
Authenticating - Authentication is in progress.
Held - Authenticator sent notice of failure. The
supplicant port is waiting for the authenticator's
held-period (page 5-19).
Same as the above command, but for the specified
port(s). If a port is not configured as a supplicant,
it does not appear in the listing.
Shows the port-access statistics and source MAC
address(es) for all ports configured on the switch
as supplicants. See the "Note", below.
Same as the above statistics command, but for the
specified port(s). If a port is not configured as a
supplicant, it does not appear in the listing.
5-23