Switching The Projector On/Off; Power Cord; Power Indicator - Panasonic PT-AE8000U Operating Instructions Manual

Switching the projector on/off

Switching the projector on/off

Power cord

Use the power cord included to prevent removal of the power cord and make sure it is fully inserted into
the projector.
Make sure the <MAIN POWER> switch is on the <OFF> side before connecting the power cord.
Use the power cord included and ensure that it is fully inserted.
For power cord handling details, see "Read this first!". (
■ Connecting
Fully insert until the tabs on the left
and right make a click sound.

Power indicator

The power indicator indicates the power status.
Check the status of the power indicator <ON (G) / STANDBY (R)>
before operating the projector.
Indicator status
No illumination or flashing
Red
Green
Orange
Attention
z The internal fan operates and cools the projector while it is preparing to power off (when the power indicator is illuminated
orange). Do not switch the main power off or remove the power cord.
Note
z When the power <
to enter projection mode.
z The projector consumes approx. 0.08 W of electrical power even when the power is off (when the power indicator is
illuminated red).
z Power consumption when the power indicator flashes red is almost the same as when the lamp is illuminated red.
28 - ENGLISH
Downloaded From projector-manual.com Panasonic Manuals
Main power is switched off.
Power is switched off. (Standby mode.)
Lit Press the power <
* Does not operate when the lamp indicator or temperature indicator is flashing.
Power is switched off (standby mode) and the [POWER ON LINK] is set to
Flashing [YES] in the VIERA Link settings.
For details about [POWER ON LINK], see [POWER ON LINK] (
The projector is preparing to project.
Flashing
Projection starts after a brief pause.
Lit Projecting.
Preparing to switch off the power.
Lit
The power is switched off after a while. (Changes to the standby mode.)
The power <
Flashing mode.
Preparing to project. Projection starts after a brief pause.
/ | > button is pressed while the projector is in the power off preparation mode, it may take some time
pages 6 to 13)

■ Disconnecting
Pull out while pushing on the tabs on
the sides.
Status
/ | > button to start projection.
/ | > button is switched on again in the power off preparation
Power indicator
page 82).
