Color Management - Panasonic PT-AE8000U Operating Instructions Manual

[PICTURE] menu
■ [COLOR MANAGEMENT]
For the selected [PICTURE MODE], you can adjust a
selected color individually with [CURSOR] mode or adjust
the six color components (Red, Green, Blue, Cyan,
Magenta, Yellow) with [RGBCMY] mode.
Adjustment results can be saved as a profile and called
later.
●Create a new profile
Note
z When the input signal is switched while adjusting,
adjustment details are not saved.
z If there is another area, which has the exact same or
similar color as the target on the same screen, these
colors will be adjusted as well.
z You can adjust all colors except white, gray and black.
z If you edit a single color to be individual different colors,
the desired color may not be achieved.
z When you execute [COLOR MANAGEMENT] while a
3D image is being displayed, only the left eye image is
displayed.
z Adjusting the selected color (when
[CURSOR] is selected for [ADJUSTMENT
MODE])
Select the desired color with a cursor and adjust.
1) Press the ◄► buttons to select [CURSOR]
in [ADJUSTMENT MODE].

COLOR MANAGEMENT

PROFILE
ADJUSTMENT MODE
START ADJUSTMENT
LOG
2) Press the ▲▼ buttons to select [START
ADJUSTMENT] and press the <ENTER>
button.
z The cross cursor (A) is displayed, and the
projected image is captured.
Screen
3) Move the cursor with the ▲▼◄► buttons
to the required place to select a color.
z Align the center of the cross cursor on the point
in the projected image to be adjusted.
52 - ENGLISH
Downloaded From projector-manual.com Panasonic Manuals
NORMAL
CURSOR
4) Press the <ENTER> button.
z [CURSOR] menu (B) and the color selected (C)
are displayed.
CURSOR
DEFAULT
ENTER
SELECT
RETURN
Screen
Note
z In some cases you may be unable to adjust when the
very edge point of the projection area is selected.
z You can create a profile only when [ADJUSTMENT
MODE] is set to either [CURSOR] or [RGBCMY]. A profile
cannot be created from both adjustments.
z White, gray and black cannot be edited.
5) Press the ▲▼ buttons to select a menu
item and the ◄► buttons to adjust each
item level.
Adjust the vividness of the
color.
[COLOR]
z Setting range:
Adjust the color tone.
[TINT]
z Setting range:
Adjust the brightness of the
color.
[BRIGHTNESS]
z Setting range:
z The default setting for each item is [0].
After adjusting, the post-adjustment color (D) is
displayed.
CURSOR
DEFAULT
ENTER
SELECT
RETURN
Screen
6) Press the <ENTER> button.
z [PROCESSING] message is displayed for a few
seconds and the result is stored in [LOG].
You can store up to 8 logs under [LOG]. Press
the <RETURN> or <MENU> button to return
to the previous menu. Repeat from step 3) to
store more adjustments.
7) Press the <RETURN> button or <MENU>
button twice.
z This returns you to the [COLOR
MANAGEMENT] menu.
COLOR 0
TINT 0
BRIGHTNESS 0
−30 to +30
−30 to +30
−20 to +20
COLOR 0
TINT 0
BRIGHTNESS 0