[Color Temperature]; [Sharpness]; [Dynamic Iris]; [Waveform Monitor] - Panasonic PT-AE8000U Operating Instructions Manual

[COLOR TEMPERATURE]

You can adjust the color temperature if the white
areas of the projected image are bluish or reddish.
Less bluish
z Setting range: -6 to +6

[SHARPNESS]

With regards to the input signal, adjust video
sharpness using one of [SIMPLE] which adjusts
horizontal direction and vertical direction
simultaneously or [ADVANCED] which adjusts each
individually.
Softer
Note
z Setting range will vary according to the selected input
signal.
z [SHARPNESS] can be adjusted using either [SIMPLE] or
[ADVANCED]. Both settings cannot be used at the same
time.
z Adjusting the [SHARPNESS].
(When [SIMPLE] is selected for the
[ADJUSTMENT MODE].)
1) Press buttons to select [SIMPLE].
PICTURE
POSITION
LANGUAGE
3D SETTINGS
2) Select [SHARPNESS] with the ▲▼
LENS CONTROL
buttons, and adjust with the
OPTION
z Adjusting the [SHARPNESS].
(When [ADVANCED] is selected for the
[ADJUSTMENT MODE].)
1) Press the ◄► buttons to select
[ADVANCED].
PICTURE
POSITION
LANGUAGE
3D SETTINGS
LENS CONTROL
OPTION
Downloaded From projector-manual.com Panasonic Manuals
Less reddish
Sharper
SHARPNESS
ADJUSTMENT MODE SIMPLE
SHARPNESS
H-SHARPNESS
V-SHARPNESS
buttons.
SHARPNESS
ADJUSTMENT MODE ADVANCED
SHARPNESS
H-SHARPNESS
V-SHARPNESS
2) Select item with the ▲▼ buttons, and
adjust with the
z Pressing the ▲▼ buttons on the screen during
adjustment switches to the [H-SHARPNESS] or
[V-SHARPNESS] adjustment screen.
H-SHARPNESS
V-SHARPNESS
z The setting range varies according to the selected
picture mode and input signal.

[DYNAMIC IRIS]

You can switch automatic adjustment of the lamp and
the lens iris on/off. This augments the video to create
a video expression with sharp contrast between light
and shade.
Switch settings
[ON]
[OFF]

[WAVEFORM MONITOR]

By using a commercial test disk etc. and setting the
luminance level of the output (brightness) signal from
a connected external device to a value within this
projector's recommended range, you can perform
adjustment so the display performance of the projector
can be fully leveraged.
1) Press the <ENTER> button.
z The [WAVEFORM MONITOR] menu is displayed.
0
WAVEFORM MONITOR
OFF
FULL SCAN(Y)
FULL SCAN(R)
FULL SCAN(G)
FULL SCAN(B)
SINGLE LINE SCAN(Y)
SINGLE LINE SCAN(R)
SINGLE LINE SCAN(G)
SINGLE LINE SCAN(B)
MONITOR POSITION
AUTO ADJUST
2) Press the ▲▼ buttons to select the
required item.
z Select [OFF] to close the waveform monitor.
3) Press the <ENTER> button.
z The waveform monitor is displayed.
0
0
Note
z For details, see "Displaying the waveform monitor" in
"Remote control operation". (
[PICTURE] menu
buttons.
Switch settings
Automatic adjustment
No adjustment
UPPER LEFT

page 33)
ENGLISH - 41
0
0