York Fitness York Racer 3100 Instruction Manual page 9

HOW TO ADJUST THE MAT ALIGNMENT AND TENSION
The alignment and tension of the platform mat (walking surface) has been set prior to shipping.
Should improper tracking of platform mat occur (walking surface moving too far to right or left on
platform) or if you find that the mat slips when you get on, these problems can be corrected
as follows:
Locate the adjustment screws on the end of the main frame.
CAUTION: Adjust the mat when treadmill is running at low speed.
Keep others away from the treadmill.
MAT SHIFTED DURING TRANSPORTATION
During transportation, the mat may have shifted to one side.
Carefully tip the unit to one side and check to see that the walking mat is resting on the two guide
hooks welded under the frame.
If you find that the mat has indeed shifted, simply pull the mat toward the center of the unit, lift up
on the mat , and reposition it so that it is once again resting on the guide hooks.
Plug the cord into the outlet and pull the switch "ON".
Allow the mat to run for several revolutions and notice if it returns to center position properly.
If the mat does not return to the center position, carry out the steps for: "MAT MOVES TO LEFT" or
"MAT MOVES TO RIGHT".
Be sure that you adjust by "
MAT MOVES TO RIGHT
If your mat tends to move to the right, then adjust the right screw by turning it
We recommend adjustments of
If your mat continues to move to the right, simply adjust the left adjustment screw, by turning
½ ½
turn counterclockwise, then test each time.
MAT MOVES TO LEFT
If your mat tends to move to the left, then the adjustment of the right screw is necessary by turning
counterclockwise.
We recommend adjustments of
If the mat continues to move to the left, simply adjust the left adjustment screw, by turning
turn clockwise, then test each time.
* SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY.
½ ½
turn only each time" to avoid over correcting.
MAT ADJUSTMENT BOLTS
- USE ALLEN KEY TO ADJUST MAT
AS INSTRUCTED BELOW.
½ ½
turn only at a time, then test each time.
½ ½
turn only at time, then test each time.
½ ½
a turn clockwise.
½ ½
*