Load System Settings; Save System Settings; Restore Default Settings And Reboot - D-Link HorstBox DVA-G3342SD Manual

7.3 System Settings

7.3.2 Load System Settings

You may want to restore the settings you saved before. To do so,
click on C
HOOSE
file. Click on O
PEN
To load the configuration file into the HorstBox, click on L
The HorstBox now checks the chosen configuration file. Please
note: Only configuration files saved whilest using the same
firmware version can be restored.
Next the device reboots twice and loads the configuration file.
Please be patient as the procedure may take up to 2 minutes.

7.3.3 Save System Settings

You may save the current system settings of your HorstBox in
a file on a hard disk (or another storage device). Use S
specify where the configuration file should be saved.

7.3.4 Restore Default Settings And Reboot

Restore the default settings if the HorstBox does not work properly
after an abortive configuration.
Click on R
ESTORE
If the admin's password is lost you no longer can manage the
HorstBox. You have to reset the HorstBox via the reset switch at
the back of the device.
• Press the reset switch for about 10 seconds (see fig. below
for details).
• Release the switch.
• The HorstBox will reboot. This may take some minutes.
• Once the reboot is finished all factory settings are restored.
The HorstBox will be reset to these values:
and in the next dialog choose a configuration
.
.
147
.
OAD
to
AVE