Installation; Preparations - D-Link HorstBox DVA-G3342SD Manual

Dsl wlan lan voip isdn analog
Table of Contents

Advertisement

2.3 Installation

2.3 Installation
Please read chapter
installing the HorstBox.

2.3.1 Preparations

Before configuring the HorstBox prepare the device as described
in this section.
• Install the HorstBox at the desired location.
• Provide for air circulation. Do not cover the HorstBox.
• Connect the HorstBox to your computer. Use the blue net-
work cable provided. Plug it into one of the blue ports of
the device. Plug the other end into the port of the network
adapter card (NIC) of your computer.
• Plug the power adaptor plug into the power port of the
HorstBox.
• Plug the power plug of the power adaptor into a socket. This
will make the HorstBox boot up.
• Boot up the computer you want to use for configuring the
HorstBox.
All preparations are done now. You can start to configure the
HorstBox after the LED reports readiness of the device. These
LEDs should be "on" by now: Power, Stat and at least 1x LAN,
assumed that the computer connected to a LAN port is ready,
too.
Note: If you plan to integrate the HorstBox into an existing
network, you may want to disable the DHCP server tem-
porarily as the HorstBox provides another DHCP server
as default. Using two DHCP servers uncontrolled in one
network may cause severe problems.
The default IP address of the HorstBox is http://horstbox.
Make sure that your network is working in the same segment
(192.168.0.x).
1.2 Installation Considerations
22
on
p.13
before

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents