Wheels; Light Bulb Replacement - Arctic Cat 350 Manual

Tire Replacement
The ATV has low-pressure tubeless tires.
Air is sealed by the contact surfaces of the
inner wheel rim and the tire bead. If either
the inner wheel rim or tire bead is damaged,
air may leak. Be extremely careful not to
damage these areas when replacing tires.
It is very important to use the proper
tools when repairing or replacing tires to
prevent damage to the tire bead or wheel
rims. If proper tools and related items are
not available, have this maintenance per-
formed by an authorized Arctic Cat ATV
dealer or a qualified tire repair station.
CAUTION
When breaking the tire bead loose
from the wheel, be extremely careful
not to damage the inner wheel sur-
face or the tire bead.
! WARNING
Use only Arctic Cat approved tires
when replacing tires. Failure to do
so could result in unstable ATV
operation.
Tubeless Tire Repair
Should a leak or flat tire occur due to a
puncture, the tire may be repaired using a
plug-type repair. If the damage is from a
cut or if the puncture cannot be repaired
using a plug, the tire must be replaced.
When operating the ATV in areas where
transportation or service facilities are not
readily available, it is strongly recom-
mended to carry a plug-type repair kit
and a tire pump along.

Wheels

1. Park the ATV on level ground and
engage the brake lever lock.
2. Loosen the lug nuts on the wheel to
be removed.
3. Elevate the ATV.
4. Remove the lug nuts.
5. Remove the wheel.
6. Install the wheel and install the lug
nuts.
7. Tighten the nuts in a crisscross pat-
tern to 4.4 kg-m (32 ft-lb).
8. Remove the jack.

Light Bulb Replacement

The wattage rating of each bulb is shown
in the chart. When replacing a burned
bulb, always use the same wattage rating.
Headlight
Taillight/Brakelight
License Plate Light
Turn Signal - Front
Turn Signal - Rear
Position Light - Front
CAUTION
Use only specified bulbs indicated
in the chart as replacement bulbs.
Headlight
NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten the
life of the bulb.
To replace the headlight bulb, use the fol-
lowing procedure.
1. Remove the wiring harness connec-
tor from the back of the headlight.
2. Grasp the bulb housing, turn it coun-
terclockwise, and remove the bulb.
3. Install the new bulb into the housing
and rotate it completely clockwise.
4. Install the wiring harness connector.
CAUTION
When replacing the headlight bulb,
be careful not to touch the glass
portion of the bulb. Grasp the new
bulb with a clean cloth.
License Plate Light
To replace the license plate bulb, use the
following procedure.
12V/35W/35W
12V/5W/21W
12V/5W
12V/10W
12V/5W
12V/5W
59 59 59 59