Service Procedures; Removal Of Lid; Components In Console Area; Removal Of Display Module - Fisher & Paykel smartload DEGX1 Service Manual

6

Service Procedures

In order to service components of the SmartLoad
followed. These procedures are set out below.
Servicing Note
(a) To avoid stripping screws, do not overtighten when re-assembling parts. If using a
power screw driver have the torque setting on low.
(b) Take extra care not to damage wire terminals on removal as some of these have
release clips.
(c) On completion of any service carried out to the dryer, all safety tests as required by
law must be carried out.
6.1

Removal of Lid

(a) Open the lid fully, then lift off vertically.
Reassembly
(a) Refit in reverse manner, ensuring that the hinge lugs
on the lid are vertical.
6.2

Components in Console Area

(a) Disconnect the unit from the power supply.
(b) Remove the lid. (Refer to Section 6.1)
(c) Remove the two screws at the rear of the console
securing the console to the top deck.
(d) Tilt the console forward.
Reassembly
(a) Refit in reverse manner.
6.3

Removal of Display Module

(a) Follow instructions for removal of the console.
(Refer to Section 6.2)
(b) Disconnect the wiring harness from the display
module.
(c) Push the tab clear and slide the module.
(d) Lift the display module clear of the console.
Reassembly
(a) Refit in reverse manner.
™
dryer, certain procedures must be
Push tab
- 41 -
Lift
Screws
Slide module