Wan Port; Static Ip - Planex GW-MF54G2 User Manual

4. WAN Port

WAN Port Click the "Setup" button to setup your WAN connection. GW-MF54G2 supports the following
： ： ： ：
connection for Internet access: Static IP, DHCP, PPPoE, and PPTP. Please click the select menu, choose
one of the connection types from the menu, and setup the configurations as the following steps.

4.1. Static IP

If you are connecting to the Internet via Static IP, please configure GW-54MFG2 as the following steps.
IP Address
Subnet Mask
Default Gateway
DNS Server 1/2/3
second and third DNS address as well. However, this is option and you may leave it blank.
Clone MAC Address: The default MAC address of GW-MF54G2 is the Network Interface Card's
(NIC) MAC address on the WAN side. If you were asked to use the NIC provided by the ISP, you
may click "Enable" and enter the MAC address of NIC provided by the ISP. We do not suggest
you to change the default MAC address, if your ISP does not ask you to change it.
Respond to WAN Ping: Ping is a common and useful tool to know the connection status of a
specified remote network device, but some malicious intruder will try to fill your network
bandwidth with a lot of PING request data packet, to make your internet connection become very
slow, even unusable. Check this box and the router will reply all inbound PING request, and when
you activate this function, not only you but all the users will be able to ping your router from
Internet.
Enable UPnP: If your operating system supports this function, you may check to enable it.
Enable IPsec pass through on VPN connection: Click the check box to enable the encryption
function.
E nter the IP address provided by your ISP.
：
E nter the Subnet Mask address provided by your ISP.
：
E nter the Gateway address provided by your ISP.
：
E nter the DNS Server's address provided by your ISP. You can enter the
：