Installation Checklist - Electrolux EIDW6105GS0 Technical & Service Manual

I I n n s s t t a a l l l l a a t t i i o o n n C C h h e e c c k k l l i i s s t t
Prior to operating the unit, check the following to assure proper installation.
1. Water and drain lines have no kinks and move freely behind the dishwasher.
2. Water supply is turned on.
3. Joints are free of leaks.
4. Wiring connections to junction box are tight all access panels are secured back in place.
5. Replace kickplate.
6. Drain hose is assembled to Drain Hose Connector.
7. All packing materials and consumer literature have been removed from inside unit.
8. Dishwasher is level and securely fastened.
9. Open and close door to make sure it does not hit surrounding cabinet or countertop.
10. Make sure that all wire ties are removed from the Adjustable Rack Assembly, Versa Tray, Utility Tray
and Silverware Baskets.
After following the checklist above, the unit should be operated through at least one fill and pump-out.
Then follow the list below.
1. On EWDW6505 press and hold SET Icon for 5 seconds before first use. On EIDW6305 and EIDW6105
press and hold down HI-TEMP Icon for 5 seconds before first use.
2. At first fill, approximately 2 minutes make sure water completely covers filter surface.
3. At pump-out: (pump-out is either when the cycle is completed or canceled. Refer to the Use and
Care Manual for Start/Cancel), make sure all water is pumped out.
4. Check water connections again for leaks.
I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
2-11