Table of Contents
Advertisement
P P u u l l l l e e y y A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
The pulley assemblies are located behind the leg
levelers on the exterior of unit. The assembly
slides into a slot formed in the frame of the unit.
To remove the pulley assemblies:
1. Remove unit from its installation to access the
pulley assemblies.
2. Remove spring tensioned cable from door
hinge.
3. Tilt unit back to access the screws along the
edge of the unit base. If blocking materials are
not available, the unit may be set on its back.
4. Using a #20 Torx bit, extract the two screws
securing the pulley assembly to the bottom of
the unit frame. (See Figure 5-13)
5. Using a phillips head screwdriver, extract the
screw passing through the lower pulley. The
pulley assembly can then be pulled out of the
locating slot.
I I n n t t e e r r i i o o r r C C o o m m p p o o n n e e n n t t s s
U U p p p p e e r r a a n n d d L L o o w w e e r r R R a a c c k k A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
The wire racks are all nylon coated, and all models
have adjustable upper racks. The models can
have different features in the lower rack.
The lower wire rack is removed by simply pulling
the lower wire rack out of the tub.
The upper rack assembly is held within the guide
rail by an end cap that snaps onto the end of the
guide rail. The end cap has molded retaining pins
that allow the end caps to rotate off the front of the
guide rail and enables the upper rack assembly to
be removed from the unit. (See Figure 5-14)
The upper rack adjusters, mounted to the sides of
the rack, are adjusted independently of each other.
To adjust the rack, press out on the adjustment
lever then raise and lower the rack as needed.
To remove the upper rack assembly:
1. Turn end cap towards the outside of the unit
until approximately 90 degrees from guide rail.
2. Pull upper rack assembly out of guide rail.
3. The adjustment assembly is removed by
extracting the two screws from the inner and
two shoulder screws from the outer plates.
(See Figure 5-15)
4. Pull the bottom of the spring clamp assembly
off of wire rack, then using a #10 Torx bit,
extract the screw securing the spring clamp to
the adjustment lever. Remove components
from wire rack.
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
F F i i g g u u r r e e 5 5 - - 1 1 3 3 . . P P u u l l l l e e y y A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
F F i i g g u u r r e e 5 5 - - 1 1 4 4 . . T T o o p p B B a a s s k k e e t t R R e e m m o o v v a a l l
Adjustment Mtg.
Screws
Inner Plate
Outer Plate Assy.
With Rollers
F F i i g g u u r r e e 5 5 - - 1 1 5 5 . . T T o o p p B B a a s s k k e e t t R R e e m m o o v v a a l l
4-7
Pulley
Assembly
Screws
End Cap
Hole for
End Cap
Pin
Spring
Adjustment
Clamp
Lever
Assy.
Shoulder Screws
Hide quick links:
Advertisement
Table of Contents
