Table of Contents
Advertisement
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
C C o o n n t t r r o o l l A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
The control assembly is mounted underneath the
valve service cover behind the kickplate. To
access the wire harness, the control assembly
must be removed from its installation position.
To remove the control assembly:
1. Remove the outer door panel.
2. Remove toe and kickplate..
4. Using a #20 Torx bit, extract the 2 screws
securing the control assembly to the unit
frame. (See Figure 5-24)
5. Release the retaining latches at the top edge
of the control assembly. Rotate control
assembly away from unit until the rectangular
locating pins line up with the slots of the con-
trol mounting bracket.
6. Carefully pull control assembly out from slots.
7. Release the retaining latches from the control
housing bracket and remove from control
assembly.
8. Prior to removing wire leads from control
assembly, label as needed to assure proper
reconnection.
9. Remove wire leads from control assembly.
The circuit board can then be lifted out of the
control assembly.
D D o o o o r r S S t t r r i i k k e e R R e e m m o o v v a a l l
The door strike is mounted to the top of the top
frame brace, with the front section slipping through
a slot in the unit frame, and secured with a screw.
(See Figure 5-25)
If door strike needs to be adjusted, loosen the
retaining screw at top of frame brace. This allows
strike to be moved as needed. Tighten retaining
screw after adjustment is made.
To remove door strike extract the retaining screw
and pull door strike from slot in frame.
Retaining Latches
Control Housing Bracket
F F i i g g u u r r e e 5 5 - - 2 2 4 4 . . C C o o n n t t r r o o l l A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
Door Strike
Slot
F F i i g g u u r r e e 5 5 - - 2 2 5 5 . . D D o o o o r r S S t t r r i i k k e e R R e e m m o o v v a a l l
4-12
Screws
Screw
Door Strike
Hide quick links:
Advertisement
Table of Contents
