Electrolux EIDW6105GS0 Technical & Service Manual page 98

T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
P P r r o o b b l l e e m m
Water in the tub is 1. The drain valve is not closed
not staying at the
proper level.
2. Drain hose not installed
At the end of the 1. The cover for the dispenser
cycle there is still
detergent in the 2. The detergent was added
dispenser.
3. The water was not hot
4. Dishwasher did not fill with
5. Detergent not handled or
Dishwasher does 1. Check cycle criteria found in
not perform all
functions in the
chosen cycle.
Dishwasher only fills 1. The wash motor may not be
and drains. Can
not hear the wash
motor running.
At the end of the 1. Type of dishes that make up
cycle dishes are not
dry. 2. Dishwasher installed in
3. Incoming water not hot
4. The rinse aid dispenser is
5. Rinse aid is not being
C C a a u u s s e e
properly.
properly.
did not open.
when the cup was wet.
enough to dissolve detergent.
the proper amount of water.
stored properly.
the Service data sheet.
operating.
the load.
closed cabinetry.
enough.
empty.
dispensed in the cycle.
C C o o r r r r e e c c t t i i o o n n
1a. Check and clean the drain valve.
1b.Check power to the drain valve from the
control to make sure the valve is closed.
1c. Check the motor of the drain valve for
resistance. Replace defective drain valve.
2a.The drain hose needs to loop all the way to
the underside of the counter top.
2b.The drain hose should not go under the
floor with out an air gap mounted in the
counter top.
1. See Problem: Dispenser is not opening.
2. Water can cause detergent to cake and not
dissolve properly. Close the cup cover
before adding fresh detergent to the cup.
3. See Problem: Dishwasher operates but
water not getting hot.
4. See Problem: Will not fill.
5. Make sure detergent is fresh and stored in
an air tight container in a dry location.
1. The cycle matrix is different for each cycle
and the control can change the cycle with
input from sensors.
1. See Problem: Wash motor not operating.
1. Plastic items do not dry well in dishwashers.
2. Ample outside air is needed for intake of
vent system.
3. Check incoming water temperature needs to
be at least 120°F.
4. Rinse aid is needed to speed evaporation of
water from the dishes. Fill rinse aid section
of the dispenser. Check setting of dispenser
and increase setting to aid in drying.
5. See Problem: Dispenser is not opening.
6-4