Table of Contents
Advertisement
D D o o o o r r C C o o m m p p o o n n e e n n t t s s
K K i i c c k k p p l l a a t t e e a a n n d d T T o o e e p p l l a a t t e e R R e e m m o o v v a a l l
The kickplate and toe plate are secured with
screws to the unit frame under the door assembly.
To remove the kickplate:
1. Remove two (2) screws at front of the kickplate
assembly using a #2 Phillips screw driver.
(See Figure 5-1)
2. Tilt and pull forward to remove.
O O u u t t e e r r D D o o o o r r P P a a n n e e l l R R e e m m o o v v a a l l
In order to access the control, door latch assembly
and dispenser, the outer door panel must be
removed from the door assembly. Screws pass
through the inner door panel and fasten into the
outer door panel.
To remove the outer door panel:
1. Open dishwasher door.
2. Extract six (6) screws from outer edge of
the door inner panel using a #20 Torx bit screw
driver. While extracting the screws, support
the outer panel to prevent damage from
occurring as the panel drops free.
(See Figure 5-2)
D D o o o o r r H H a a n n d d l l e e R R e e m m o o v v a a l l
The door handle is secured with two phillips heads
screws that pass through a support plate and the
outer door panel and then fasten into the door
handle assembly.
To remove the door handle:
1. Remove the outer door panel.
2. Using a #2 Phillips head screwdriver, extract
the two screws securing the door handle to the
outer door panel. (See Figure 5-3)
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
F F i i g g u u r r e e 5 5 - - 1 1 . . K K i i c c k k p p l l a a t t e e a a n n d d T T o o e e p p l l a a t t e e R R e e m m o o v v a a l l
F F i i g g u u r r e e 5 5 - - 2 2 . . O O u u t t e e r r D D o o o o r r P P a a n n e e l l R R e e m m o o v v a a l l
F F i i g g u u r r e e 5 5 - - 3 3 . . D D o o o o r r H H a a n n d d l l e e R R e e m m o o v v a a l l
4-3
Screws
Screws
Hide quick links:
Advertisement
Table of Contents
