Support Software; Installing The Support Software - Procom BST1M Series User Manual

BST1M Series User's Manual

Support Software

All versions of this motherboard come with a soft-
ware Support Disk that has both support software
and bundled software on it. The Support Disk is for
an entire range of motherboards. There is more soft-
ware on the Support Disk than is used by this moth-
erboard, so don't be confused by the software that
doesn't apply. An Operating System must be in-
stalled on the primary system hard disk drive before
you can install support software. Most of the support
software is for Microsoft Windows 95, 98 or NT as
these are the operating Systems most likely to be
used with this motherboard.

Installing the Support Software

The Support Disk is set to run automatically. The
disk has an installation interface that will appear
when you load the disk in the CD-ROM drive. You
can then make selections from the menu that appears
by clicking on an item with the mouse. You can also
use the arrow keys on the keyboard to make a selec-
tion and then press the Enter key.
The installation interface has a number of nested lev-
els. The top level, which you see when the disk loads
looks like the following figure. You can exit the level
you are in either by clicking on the Exit bar, select-
ing it and pressing the Enter key or by pressing the
Esc key. The top level Exit bar closes the installation
program.
You will need to install the SiS 630 support software
under the SiS Series heading. Installing the other
bundled software is optional.
26